1. PRE-DEPLOYMENT INSPECTION: Visually inspect both gloves for holes in the fingertips or palm, separated seams, and non-functional hook-and-loop closure. Confirm both gloves are dry and free of caustic contaminants from previous use.

2. DONNING THE GLOVE: Insert your hand fully into the glove, ensuring each finger is completely seated to preserve dexterity. Pull the cuff down to the base of the wrist before securing the closure.

3. SECURING THE WRIST CLOSURE: Fasten the hook-and-loop wrist strap snug enough to prevent rotation during dynamic tasks, but not so tight as to restrict blood flow or wrist movement. Repeat the donning and securing process for the second hand.

4. OPERATIONAL USE: Use the synthetic leather palm for positive tool control on oily or contaminated surfaces. Rely on the reinforced fingertips and high-dexterity design for precise manipulation of small components such as bolts, wires, retaining pins, and electrical connectors.

5. FLUID SATURATION PROTOCOL: If gloves become saturated with oil, fuel, or any external fluid during the task, remove and replace them immediately. Grip capability and operator safety are compromised once saturation occurs.

6. DOFFING WITHOUT CONTAMINATION: Release the hook-and-loop closure on one wrist. Grasp the glove at the palm-side cuff and pull it off, turning it inside-out as it comes free.

7. REMOVING THE SECOND GLOVE: Hold the removed glove in your still-gloved hand. Slide two fingers of the bare hand under the cuff of the remaining glove, making contact only with the interior surface. Peel the second glove off over the first, containing the contaminated exterior inside.

8. POST-OPERATION INSPECTION AND SUSTAINMENT: Inspect palms, fingers, and seams for new wear, holes, or thread fraying. Clean with mild soap and cool water, squeeze out excess moisture, and hang to dry in a ventilated area away from direct sunlight or heat sources.

---